Gener al maintenance, Engineering mode menu – Spirit XBR55 User Manual
Page 28
24
Fitness Bike
XBR55
The console has built in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key
is pressed for example. To enter the Engineering Mode Menu, press and hold down the Start,
Stop and Enter keys. Keep holding the keys down for about 5 seconds and the Message
Center will display Engineering Mode Menu. Press the Enter button to access the menu below:
a. Key Test (Will allow you to test all the keys to make sure they are functioning)
b. Security (Allows the keypad to be locked to prevent unauthorized use)
c. Functions (Press Enter to access settings and Up arrow to scroll)
i.
Sleep Mode (Turn on to have the console power down automatically after 20 minutes of
inactivity)
ii. PWM Test (Tests the brake resistance)
iii. Beep (Turns off the speaker so no beeping sound is heard)
iv. Units (Sets the display to readout in English or Metric display measurements)
v. ODO Reset (Resets the odometer)
vi. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause indefinitely)
d. LCD Test (Tests all the display functions)
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
I.
The hardware was not sufficiently tightened during assembly. All bolts that were installed
during assembly need to be tightened as much as possible. It may be necessary to use a larger wrench
than the one provided if you cannot tighten the bolts sufficiently. I cannot stress this point enough; 90% of
calls to the service department for noise issues can be traced to loose hardware.
II. The crank arm nut needs to be retightened
III. If squeaks or other noises persist, check that the unit is properly leveled. There are 2 leveling pads on the
bottom of the rear stabilizer, use a 14mm wrench (or adjustable wrench) to adjust the levelers.
Gener
al Maintenance
Engineering Mode Menu