Spirit XBR55 - Manual (Page 27)

23
Fitness Bike
XBR55
Note: You must wear the heart rate transmitter strap for these programs
Both programs operate the same, the only difference is that HR1 is set to 60% and HR2 is set
to 80% of the maximum heart rate. They both are programmed the same way.
To start an HR program follow the instructions below or just select the HR1 or HR2
program, then the Enter button and follow the directions in the Message Center.
After selecting your heart rate target the program will attempt to keep you at or within 3-5
heart beats per minute of this value. Follow the prompts in the Message Center to
maintain your selected heart rate value.
1. Press the HRƒ1 or HRƒ2 key then press the Enter key.
2. The Message Center will ask you to enter your Age. You may enter your age, using the
LevelƒUp/Down keys, then press the Enter key to accept the new value and proceed
on to the next screen.
3. You are now asked to enter your Weight. You may adjust the weight value using the Levelƒ
Up/Down keys, then press Enter to continue.
4. Next is Time. You may adjust the time and press Enter to continue.
5. Now you are asked to adjust the Heart Rate Target. This is the heart rate level you will
strive to maintain during the program. Adjust the level using the LevelƒUp/Down keys,
then press Enter.
Note: The heart rate that appears is based on the % you accepted in Step 1. If you
change this number it will either increase or decrease the % from Step 1.
6. Now you are finished editing the settings and can begin your workout by pressing the
Start key. You can also go back and modify your settings by pressing the Enter key.
Note: At any time during the editing of Data you can press the Enter key to go back one screen.
7. If you want to increase or decrease the workload at any time during the program press
the LevelƒUp/Down key. This will allow you to change your target heart rate at any
time during the program.
8. During the HR 1 or HR 2 programs you will be able to scroll through the data in the
Message Center by pressing the Enter key.
9. When the program ends you may press Start to begin the same program again or Stop
to exit the program or you can save the program you just completed as a custom user
program by pressing a User key and following the instructions in the Message Center.
Heart Rate Program Operation