Sharp DS 24D - Manual (Page 22)

39
VIEWING THE NEXT CALLER ID CALL
In the event that you have a call waiting or a camped-on call at your keyset,
you can press the NEXT key to display the Caller ID information associated
with the call in queue at your keyset. Either the CID name or CID number will
show in the display depending on your Name/Number selection.
To view Caller ID information for calls that have been camped-on to your key-
set, press the NEXT key. If your keyset does not have a NEXT key, press the
CID key and then the NEXT soft key.
SAVING THE CALLER ID NUMBER
At any time during an incoming call that provides CID information, you may
press the SAVE key to save the CID number. If your keyset does not have a
SAVE key, press the CID key, the SCROLL key and then the SAVE soft key.
The system must be using LCR to dial the saved number.
REDIALING A SAVED CALLER ID
NUMBER
To redial a number that has been saved, press the SAVE key or dial 17.
NOTES:
1.
Your telephone system must have LCR correctly programmed to redial
the saved number.
2. If the Hot Keypad feature has been turned off, you must first lift the hand-
set or press the SPEAKER key before you begin dialing.
STORING A CALLER ID NUMBER
At any time during an incoming call that provides CID information, you may
save the CID number as a speed dial number in your personal speed dial list.
To store a Caller ID number in a personal speed dial bin:
• Press the STORE key. The system displays the speed dial bin in which
the number was stored, OR
• Press the CID key and then press the SCROLL key.
• Press the STORE soft key.
• The system displays the speed dial bin in which the number was stored.
NOTE: Your telephone system must have LCR correctly programmed to re-
dial the saved number. If LCR is not being used on your system, you will not
be allowed to STORE CID numbers.
WHAT IS CALLER ID?
Caller ID is the name given to the telephone company-provided feature that
delivers the telephone number and sometimes the name of the person call-
ing your phone.
The Samsung DS 616 system supports Caller ID and in fact in the case
where the number only is delivered, the system can be programmed to
insert a name for a specific telephone number received. Up to a maximum
of 200 numbers can be programmed.
Caller ID is provided by telephone companies as a charged service on ana-
log PSTN lines. However, there are some circumstances where you will not
receive the information. The most common reasons for this are:
• The caller has requested the Telephone Company to stop their tele-
phone number being sent.
• The caller is calling from an area that cannot provide Caller ID, e.g. inter-
national calls.
• Callers are calling from a pay phone.
• The Caller ID information is corrupted when received from the telephone
company.
• The Telephone Company does not send the Caller ID.
• The Telephone Company may send the name MOBILE to the system.
SELECTING YOUR CALLER ID
DISPLAY
You can decide if you want to see the Caller ID name or Caller ID number in
the display. Regardless of which one is selected, you can press the NND
key to view the other pieces of Caller ID information. To select the type of
Caller ID information you wish to view first:
• With the handset on-hook, press TRANSFER and then dial 119.
• Dial 0 if you do not wish to view CID information, 1 to view the NUMBER
first or 2 to view the NAME first.
• Press TRANSFER to exit and store your selection.
38