Sony CMT-EX100 - Manual (Page 16)

16
Waking up to music (continued)
7
Press . or > repeatedly to select
the desired sound source.
The indication changes as follows:
* Select “PC/TAPE” to use an optional
component connected to the PC/TAPE jacks as
the sound source.
8
Press ENTER on the remote.
The start time, the stop time, and the sound
source appear in turn, before the original
display returns. “DAILY” lights up.
9
Press ?/1 to turn off the system.
Other Operations
To Do this
Check the setting Press CLOCK/TIMER
SELECT on the remote
repeatedly until “DAILY”
appears. The start time,
followed by the stop time, the
sound source appears, then
original display appears.
Cancel the timer
Change the setting
Press CLOCK/TIMER
SELECT on the remote
repeatedly until “TIMER
OFF” appears.
Notes
• If the system is on about 30 seconds before the
preset time, the Daily Timer will not be activated.
• Do not operate the system from the time the system
turns on until the play starts (about 30 seconds
before the preset time).
• Once you set the Daily Timer, it functions every
day until you cancel it.
Optional Components
Hooking up the optional
components
You can connect a digital or an analog
component to this system.
To connect optional components, remove the
small rear cover first.
To the audio output
jacks of an optional
component
PHONES jack To the digital input jack of
a digital component
To Do this
Make a digital
recording to a
digital component Connect a optical cable.
Make an analog
recording to an
analog component Connect the audio cords.
Listen to the
connected optional
component Press FUNCTION repeatedly
until “PC/TAPE” appears (or
press PC/TAPE on the remote).
Listen through the
headphones Connect the headphones to the
PHONES jack.
Start over from step 1.
To the audio input
jacks of an optional
component