beautypg.com

Speaker setup, Speaker setting methods – Samsung 20041112184341515 User Manual

Page 17

background image

GB

Speaker Setup

31

GB

32

When 5.1 Channel Surround Sound is played, you
can enjoy the best sound if the distance between
you and each speaker is the same. You can set
Delay Time in the Center/Rear Speaker to
customize the sound to the acoustics of your room.

Setting Center Speaker

If the distance of Dc is equal to or longer than the
distance of Df in the figure, set the mode as 0ms.
Otherwise, change the setting according to the
table on the table.

Setting Rear Speakers

If the distance of Df is equal to the distance of Ds
in the figure, set the mode as 0ms.
Otherwise, change the setting according to the
table.

To set the delay time

Df

Dc

Ds

Speaker Setting Methods

R

Distance of (A)

50

100
150
200

Value

1.3ms
2.6ms
3.9ms
5.3ms

Distance of (B)

200

400

600

Value

5.3ms

10.6ms

15.9ms

(A)=Df-Dc

(B)=Df-Ds

Dc: Distance from center speaker to

listening position

Df: Distance from front speakers to

listening position

Ds: Distance from rear speakers to

listening position

Ideal Center Speaker Position

Ideal Rear Speaker Position

Arrange all speakers within a circle
as shown in the figure.

Front Speakers

Center Speaker

Rear Speakers

Subwoofer Speaker

Set the front speakers so that their tweeters (high-range) are
aligned at about ear level and at a horizontal angle of 45° to the
prime listening position.

Ideally the center speaker should be positioned with its top
surface flush with the front speakers. However, you may place
the speaker either on top or near the bottom of your TV set.

Place the subwoofer at any convenient location within
the vicinity of the listening position.

Set the rear speakers further back, parallel to the walls,
at 60 to 90 centimeters (2 to 3 feet) above prime listening
position ear level.
If the space behind the listening position is insufficient
(i.e., too close to the wall), place the rear speakers facing
each other on either side.

Setting up Speaker Mode and Delay Time

Each time the button is pressed, a different mode selection is
displayed on the front panel display as shown below.

SPK Mode

The display changes depending on the current audio output
mode (DSP, PRO LOGIC, 3-STEREO, STEREO, etc.).

When in the speaker mode, the center and rear speakers and
the subwoofer cannot be selected.

DIGITAL

L

LFT

R

F SP SMALL

C SP SMALL

R SP SMALL

SW SP USE

DIGITAL

L

LFT

R

DIGITAL

L

LFT

R

DIGITAL

L

LFT

R

DIGITAL

L

LS

RS

C

LFT

R

R

MS

DIGITAL

L

LS

RS

C

LFT

R

DEL

S
p

e
a
k
e

r

M

o
d
e

Delay

Time

Front speaker: Small

Center speaker: Small

Rear speaker: Small

Subwoofer: Use

Center Speaker Delay Time

Rear Speaker Delay Time

Setting up Delay Time from 00~05ms

Setting up Delay Time from 00~15ms

Press the SPK Mode button.

SMALL: When this setting is selected, low frequencies of below 200 Hz are assigned to

the subwoofer only.

USE: Select when using speakers.