beautypg.com

Reference, Care and maintenance, Troubleshooting – Sony XR-MS5 User Manual

Page 15: 14 en

background image

14

En

Care and maintenance

Occasional care and maintenance of the unit and the software
are needed to optimize the performance of your unit.

To clean the cabinet
Use a soft and dry cloth. If the unit surfaces are extremely
dirty, use a soft cloth lightly moistened with mild detergent
solution. Do not use strong solvents such as alcohol, benzene
or thinner.

Care of CDs
When a CD becomes dirty, wipe it from the center out with a
cleaning cloth. After playing a CD, store it in its case. Do not
keep it in hot or humid places.

Troubleshooting

If your unit fails to perform properly, check the following guide
and the relevant sections of this manual.

There is no sound
•Are the speakers and AC power cord connected properly?

The unit shut off suddenly
•Possibly a short circuit in the speaker terminals. Disconnect

the AC power cord from the AC outlet and reconnect the
speaker cords correctly.

All the display lights turn off when the power is off
•Is ECO mode set to on?

Erroneous display
•Reset the unit.

REFERENCE

3 Within 7 seconds, press ENTER.

The timer-on time and the source name appear alternately
on the display.

4 Press f or g to set the timer-on time, then

press ENTER.

5 Press f or g to set the timer-activated

duration, then press ENTER.
With each press, the timer-activated duration changes in
5-minute steps between 5 to 240 minutes.
If there is no button input for 4 seconds, the current setting
is entered automatically.
• VOLUME/MULTI JOG is also available in place of f

or g.

6 Adjust the volume and tone for timer playback.

If the volume level is set to 22 or higher, it is automatically
turned down to 21 when the unit is turned on by the timer.

7 Prepare the source.

To play CD, insert a disc.
To play the radio, select the band and tune in the desired
station.
To play external equipment connected to the VIDEO/AUX
jacks, set an external timer for the equipment so that its
playback begins at the same time.

8 Press POWER 6STANDBY/ON to turn the unit

off.
"5" remains on the display to indicate the timer standby
mode (when the ECO mode is deactivated).
At timer-on time, the unit turns on and plays the selected
source. After the specified timer-activated duration, the
unit turns off again.

•Timer playback will not begin unless the unit is turned off

first.

•Connected equipment cannot be turned on or off by the built-

in timer of this unit. Use an external timer.

To check the timer setting
Hold down SHIFT and press TIMER.
The timer-on time, the source and the timer-activated duration
are displayed for 4 seconds.

To change the timer setting
Reset the timer again.

To cancel the timer
On the main unit
Press JOG MODE to display "TIMER

5 PLAY" and turn

VOLUME/MULTI JOG so that "TIMER OFF" is displayed.
Then press ENTER. "5" disappears from the display.

On the remote control
Hold down SHIFT and press TIMER repeatedly until
"TIMER OFF" is displayed. "5" disappears from the
display.

Tip:
Your timer setting is retained even if the timer is canceled.
Next time the timer is activated, you can change your previous
setting, or simply use the same setting again.