Sony XR-MS5 - Manual (Page 10)

9
En
Setting the clock
1 Hold down SHIFT and press CLOCK on the remote
control.
When the unit is turned off, you can also press a or
ENTER.
2 Press f or g to set the time.
Each press changes the time in 1-minute steps.
Holding these buttons down will vary the time in 10-minute
units.
If f or g is not pressed within 4 seconds, setting
is canceled.
• You can also turn VOLUME/MULTI JOG to the right to
advance the time and to the left to move the time back.
The speed with which the time changes varies according
to how fast you turn VOLUME/MULTI JOG.
3 Press a or ENTER.
The time display stops flashing and the clock starts from
00 seconds.
To display the time while the power is on
Hold down SHIFT and press CLOCK on the remote control.
The time will be displayed for 4 seconds.
To switch to the 24-hour standard
Display the time and press s within 4 seconds.
With each press, the clock alternates between 12- and 24-
hour standard time.
Tip:
In the 12-hour standard, "AM12:00" indicates midnight and
"PM12:00" noon.
If the clock display flashes when the unit is turned
off
There has been a power interruption. Reset the clock.
Graphic equalizer
Selects a sound equalization curve to match the music type.
Press EQ repeatedly to select one of the three
equalization curves.
- ROCK: Powerful sound emphasizing treble and bass
- POP: More presence in the vocals and midrange
- JAZZ: Accented lower frequencies for jazz-type music
To cancel equalization
Press EQ repeatedly until the selected levels go off.
BBE
Enhances high frequencies for sound clarity.
Press BBE repeatedly to select one of the three
enhancement levels or the off position.
•If the sound becomes distorted with the BBE effect, cancel
the effect.
T-BASS
Emphasizes low frequencies for a powerful sound.
Press T-BASS repeatedly to select one of the three
emphasis levels or the off position.
•If the sound becomes distorted with the T-BASS effect, cancel
the effect.
SOUND ADJUSTMENTS
Q SURROUND system
The Q SURROUND system built into this unit uses only two
speakers at the left and right to create an atmosphere that
sounds as if you are surrounded by two front speakers and
two rear speakers.
Press QSURROUND until "Q-SUR" appears on the
display and the QSURROUND indicator lights up.
To cancel the Q SURROUND effect
Repeat the above so that the QSURROUND indicator goes
off.
Tip:
•The Q SURROUND system does not work in monaural
mode.
•When the Q SURROUND system is on, the sound may be
distorted at higher volumes. If this happens, turn the
volume down.