Southbend HDG-60E - Manual (Page 6)

S
PECIFICATIONS H
EAVY
D
UTY
C
OUNTERLINE
O
NS Figure 2
1.5"
24.0"
30.0"
Top View
Front View
11.0"
2.8"
5.4"
Width (see table below) 31.5"
16.0"
15.1"
10.0"
2.0"
29.4"
Side View
SPEC
IFICATI
DIMENSIONS OF GRIDDLE MODELS
Model Width Number and Size of Burners Total BTU
HDG-24 & HDG-24E 24" 2 @ 30,000 60,000
HDG-36 & HDG-36E 36" 3 @ 30,000 90,000
HDG-48 & HDG-48E 48" 4 @ 30,000 120,000
HDG-60 & HDG-60E 60" 5 @ 30,000 150,000
CONSTRUCTION OF GRIDDLE MODELS
The front, sides, and 5" riser are all stainless steel. The rear and bottom panels are aluminized steel. The
reinforced double-wall sides are fully insulated.
The griddle surface is high-carbon, 1" thick, polished steel plated with trivalent chromium. The chrome plate
has an emissivity rating of approximately 0.08.
Each foot of griddle plate is heated by a U-shaped burner controlled by a thermostatic gas valve for
independent temperature control. Each pilot is equipped with a flame failure safety device.
The base of a 60" griddle consists of the base of a 24" griddle and a 36" griddle connected together,
spanned by a 60" griddle surface with one grease duct and one grease drawer.
P AGE 6 O PERATOR ’ S M ANUAL 1182845 REV 6