Southbend HDG-60E - Manual (Page 11)

H
EAVY
D
UTY
C
OUNTERLINE
I
NSTALLATION
Step 2b: Installation Directly on a Non-Combustible Countertop Surface
The appliance may be installed directly onto a flat NON-COMBUSTIBLE surface, as follows:
1. Place the appliance in the position that it will be used. Lift the appliance only from the ends, never from
the middle!
2. Connect the gas supply (see Step 4 on page 18), then return to this procedure.
3. Check that the appliance is in the position you want it to be in. INSTALLATION
4. Seal the appliance to the countertop using G.E. or Dow Corning RTV, or the equivalent (as shown in
Figure 6 below). Consult local codes for exact requirements. A small bead of RTV around all four
bottom edges should be adequate. Open the front door to seal along the front edge of the frame.
5. Go on to Step 5 on page 19.
Figure 6
O PERATOR ’ S M ANUAL 1182845 REV 6 P AGE 11