Sharp CD-BA2600 - Manual (Page 27)

27
CD-BA250(U)3.fm 00/12/4
Ad
v
a
nced Fe
atur
es
- Ti
mer
a
nd S
le
e
p Oper
a
ti
o
n
-
To reset or change the timer setting:
Perform "Timer playback or Timer recording" from the beginning.
Notes:
„
Sleep operation
To cancel the sleep operation:
Press the ON/STAND-BY button while the sleep timer is set.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button while the sleep timer is set.
The remaining sleep time is displayed for about 5 seconds.
Note:
Once the sleep time is set, it will remain unchanged until the setting is changed.
6
Press the TUNING/TIME ( or ) button to specify the minute, then
press the MEMORY/SET button.
7
The unit will enter the timer stand-by mode automatically.
To cancel the timer playback/timer recording:
Press the ON/STAND-BY button to turn the power on.
8
When the preset time is reached, playback or recording will start.
The volume will increase gradually until it reaches the volume you were listening
at before your system enters the timer stand-by mode.
9
In timer playback:
If you select CD or TAPE, the unit will enter the stand-by mode after the play-
back. If you select TUNER, it will enter the stand-by mode one hour after the tim-
er playback starts.
In timer recording:
When the recording tape reaches its end, the timer recording will end, and the
unit will enter the stand-by mode.
z Once the time is set, the setting will be retained until a new time is entered.
z When performing timer playback or recording using another unit connected to the
VIDEO/AUX jacks, select "VIDEO/AUX" in step 2.
At this time, only this unit will be turned on or enter the power stand-by mode auto-
matically. It will enter the power stand-by mode when the end of the recording tape
is reached in timer recording or 1 hour after the playback starts in timer playback.
However, another unit will not be turned on or off.
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until "SLEEP" is dis-
played.
To change the sleep time:
While the sleep time is displayed, press the TUNING/TIME ( or ) button.
(Maximum: 3 hours - Minimum: 1 minute)
z 3 hours - 5 minutes 5-minute intervals
z 5 minutes - 1 minute 1-minute intervals
3
Press the MEMORY/SET button.
4
Your system will enter the power stand-by mode automatically af-
ter the preset time has elapsed.
The volume will be turned down 1 minute before the sleep operation finishes.
Listening to the Radio (See page 20.)