Auto sync (auto sync adjustment), Auto power off function, Auto restart function – Sharp PG-D3510X User Manual
Page 54: Speaker setting, Selecting the transmission speed (rs-232c), Adjusting the projector function, Prj - adj1/2” menu), Rs-232c), 1 auto sync (auto sync adjustment), 2 auto power off function
50
Adjusting the Projector Function (“PRJ-ADJ1/2” Menu)
Q PRJ-ADJ1
SEL./ADJ.
ENTER
END
Auto Power Off
On
Auto Restart
On
Speaker
On
Off
Keylock
9600bps
System Lock
RS-232C
Fan Mode
Normal
Disable
Auto Sync
On
Pict.
SCR
PRJ-ADJ1
SIG
PRJ2
Net.
1
2
3
4
5
7
6
8
1 Auto Sync (Auto Sync
Adjustment)
Selectable
items
Description
On
Auto Sync adjustment will occur when
the projector is turned on or when the
input signals are switched, when
connected to a computer.
Off
Auto Sync adjustment is not
automatically performed.
Auto Sync adjustment is also performed by
pressing AUTO SYNC.
The Auto Sync adjustment may take some
time to complete, depending on the image of
the computer connected to the projector.
When the optimum image cannot be achieved
with Auto Sync adjustment, use manual
adjustments. (See page
•
•
•
Note
2 Auto Power Off Function
Selectable
items
Description
On
When no input signal is detected for
more than 15 minutes, the projector will
automatically enter Standby mode.
Off
The Auto Power Off function will be
disabled.
When the Auto Power Off function is set to
“On”, 5 minutes before the projector enters
Standby mode, the message “Enter STANDBY
mode in X min.” will appear on the screen to
indicate the remaining minutes.
•
Note
Q PRJ-ADJ2
Pict.
SCR
PRJ-ADJ2
SIG
Net.
SEL./ADJ.
ENTER
END
COMPUTER2 Select
DLP
®
Link
TM
h
Off
Monitor Output
FUNCTION Button
Input Search
STANDBY Mode
Quick Start
0
min
0
Lamp Timer(Life)
100%
DLP
®
Link
TM
Invert
Quick Start Menu
On
PRJ1
All Reset
9
0
3 Auto Restart Function
Selectable
items
Description
On
If the power cord is unplugged from the
outlet or the breaker switch is turned off
when the projector is on, then the
projector automatically turns on when
the power cord is plugged into the AC
outlet or the breaker switch is turned on.
Off
The projector does not turn on
automatically when the power cord is
plugged into the AC outlet or the
breaker switch is turned on.
4 Speaker Setting
Selectable
items
Description
On
The audio signal is output from the
internal speaker.
Off
The audio signal is not output from the
internal speaker.
5 Selecting the Transmission
Speed
(RS-232C)
Make sure that both the projector and
computer are set for the same baud rate.
Selectable
items
Description
9600bps
38400bps
115200bps
Transmission speed is slow.
Transmission speed is rapid.