Shindaiwa Multipurpose Pole Pruner Attachment 78701 T230 - Manual (Page 8)

8
Lower Tube
Tube Clamp
Clamp
Screw
Handle Grip
Throttle Cable
Assembly
Main
Shaft
3. Position the outer tube so the stop
switch is facing up and the throttle
cable/wire assembly is on top. See
Figure 12.
4. Use the Allen wrench to tighten the
clamp screw firmly. Make sure the
D-shaped shim washer is in place.
(Review Figure 7, pg. 11.)
Figure 12
Reconnecting the Throttle Cable, Switch Wires
Connect The Throttle Cable.
1. Loop the ribbed cable assembly to the top left side of the engine. Confirm that the
black ground wire (with an eyelet on the end) is located between the two cable
adjuster nuts as shown in Figure 13.
2. Connect the Z-shaped end of the throttle cable to the throttle lever on top of the
carburetor as shown in Figure 14.
3. Turn the cable adjuster nuts sufficiently for the throttle cable to fit in the notch
on the fan cover. Make sure the ignition ground lead is located on the rearward
side of the notch. Then, connect the male fitting of the red ignition wire into the
female fitting of the red wire attached to the engine. See Figure 15.
Cable Adjuster Nuts
Ignition Ground
Lead (black)
Throttle
Cable End
Throttle
Cable
End
Ignition
Ground
Lead (black)
Notch
Female Ignition
Wire Fitting
Figure 14
Figure 13
Figure 15