Shindaiwa Multipurpose Pole Pruner Attachment 78701 T230 - Manual (Page 6)

6
Specifications
Length mounted on T230 w/10 inch bar ......... 1991 mm (78.4 in)
Dry Weight (Tool only)with bar and chain.........0.91 kg (2.0 lbs)
Guide Bar........ 3/8" pitch, .043" gauge, 10-inch Micro Lite™
Chain Type................................ 3/8" pitch Micro Lite™,.043" gauge Sprockets ..............................................................3/8-inch, fixed spur
Gearcase Ratio...........................................................................1.06 : 1
Chain Lubrication ....................................Automatic adjustable oiler
Oil Tank Capacity........................................................100 ml./3.9 oz.
Specifications are subject to change without notice.
1. Place the T230 or PB230 on a clean flat
surface, in an upright position.
2. Remove the cylinder cover as instructed
in your unit owner's manual.
3. Loosen the inner throttle cable adjusting
nut with a 10 mm wrench.
4. Lift the throttle cable housing out of the
notch on the powerhead.
5. Remove the throttle cable from the car-
buretor by lifting the Z-shaped cable end
out of the hole. See Figure 5.
Installing The Attachment:
Remove Outer Tube From Powerhead
Hex wrench
Shim washer
Tube clamp
Figure 7
Figure 6
Cable
adjusting
nuts
Red
switch
wire
Black
ignition
ground
lead
Figure 5
Pull Z-shaped cable end out of hole
on throttle arm
Figure 4
Lift the corner of the cover
Loosen knob
and disconnect
spark plug
cap
NOTE:
The steps on page 11 through 15 are not necessary for models AH230 and AH231 because they come equipped with an interlock-
ing throttle grip assembly as standard equipment.
6. Disconnect the red stop switch wire by
unplugging the bullet connector.
7. Use the 4 mm hex (Allen) wrench to
loosen the tube clamp screw. See Figure
7. Loosen, but don't remove the screw,
or the D-shaped shim washer will fall
out.
8. Pull the tube assembly out of the clamp.
Set the powerhead aside.