Shindaiwa Multipurpose Pole Pruner Attachment 78701 T230 - Manual (Page 10)

10
1. Place the re-gripped T230, PB230, or AH230 on a clean, flat surface in an upright
position.
For the T230/T231 Trimmers:
2. Loosen, but don't remove the gearcase clamp screw and nut using a 4 mm hex
wrench and an 8 mm open end wrench.
3. Use the 4 mm hex wrench to loosen the gearcase index screw until it is almost
free.
4. Use the 4 mm hex wrench to loosen the four debris shield attachment screws. Loosen
them only enough to free the debris shield assembly from the outer tube. This will make it
easier to reattach the debris shield when converting back to a trimmer.
5. Pull and rotate the debris shield, gearcase, and trimmer head assembly until it slides
off the outer tube. Note: the gearcase and debris shield are connected by the clamp
screw.
NOTE:
The gearcase and debris shield are connected by the clamp screw.
6. The debris shield has two spacers located on either side of the outer tube and
the debris shield bracket. Put the shims and the debris shield/gearcase assem-
bly in a safe place, so that they can be reinstalled later if desired.
Removing the Trimmer/PowerBroom Attachment
Loosen debris
shield screws
Figure 19
Loosen
index
screw
Loosen clamp
screw
For the PB230 PowerBroom:
1. Using a 5 mm hex wrench and a 10 mm open end wrench, loosen, but don't remove, the
gearcase clamp screw.
2. Using the 4 mm hex wrench, back out the index screw until it is almost free.
3. Pull and rotate the gearcase/sweeper drum assembly until it slides off the outer tube.
4. Remove the spacer from the outer tube if it did not slide off with gearcase/ sweeper drum
assembly. Put the spacer and gearcase/sweeper drum assembly in a safe place, so they
can be reinstalled later if desired.
5. If your PB230 is equipped with the optional guard assembly, it, too, must be removed. Use
4 mm hex wrench to remove its four clamp screws. Slide the protective collar off the outer
tube.
Pull assembly
off of outer tube
Figure 20 Keep shims
For the AH230/AH231
Hedge Trimmers:
1. Loosen, but don't remove the gearcase clamp screw using a 4 mm hex wrench.
2. Use the 4 mm hex wrench to loosen the gearcase index screw until it is almost free.
3. Pull and rotate the gearcase/articulating hedge trimmer assembly until it slides off the
outer tube.
NOTE:
For help reinstalling the original gearcase and attachments, consult the owner's manual
that came with your T230, T231, AH230, AH231, or PB230.