Sharp 20F640 - Manual (Page 43)

43
43
Dimension: 140mm x 215mm
Operation of Remote Control (Continued)
3 2 1
6 5 4
9 8 7
100 0
TV • CATV • VCR • DVD
A B C D
PERSONAL PREFERENCE
9 VCR-CH 8
FLASHBACK
POWER (DVD/VCR)
REC
PLAY
:
L STOP FWD
)
REW
(
PAUSE
J
POWER
DISPLAY INPUT
ENTER
; :
CH
8 VOL
–
VOL
+
9
CH
MENU MUTE g SKIP f
CATV TV
DVD VCR
L HOW TO IDENTIFY A DVD
The remote control may already be set to
operate your DVD. Try this initial check before
going on to the following “identify” section.
(1) Press CATV/DVD button.
(2) Point remote towards DVD and press POWER
(DVD/VCR) .
(3) Does the remote turn the DVD ON and OFF?
• If yes, the remote is ready to operate the DVD
and no further steps are needed.
• If no, continue to the “identify” section.
L To identify your DVD – Direct Entry Method.
Use the following steps and list to quickly find
the remote control code for your accessory
DVD.
• First look up your DVD’s remote control code
number before going through the direct code
entry steps control.
(1) Press CATV/DVD button.
(2) Press and hold down INPUT and
on your remote control.
Then release both buttons.
(3) Within ten seconds after releasing INPUT and
, enter your DVDs two-digit remote
c o n t r o l c o d e n u m b e r u s i n g R E M O T E
KEYPAD (refer to list).
• The remote control is now ready to send
commands to your DVD.
DVD BRAND
REMOTE CONTROL
CODE NUMBER
Denon 02
JVC 09
Magnavox 04
Marantz 04
Mitsubishi 06
Panasonic 02
Philips 04
Pioneer 08
Proscan 03
RCA 03
Samsung 07
Sharp 01, 10
Sony 05
Toshiba 04
Yamaha 02
Zenith 04
Note:
Depending on the model, year produced, brand,
and type of DVD, some models may not be
compatible with the remote control.
TV POWER
REMOTE
KEYPAD
POWER
(DVD/VCR)
CATV/DVD-TV/VCR
DISPLAY
CHANNEL UP (,)/
DOWN(9)
INPUT
20F640
CH s
CH s