Siemens Electrical Lean Switch - Manual (Page 49)

Diagnostics over Industrial Ethernet
Industrial Ethernet
A5E00152007-03
49
4. Once you have selected the language, the menu shown in Figure 6-2 opens.
Select a network adapter with Settings -> Network Adapter.
All the network interfaces (maximum of four) found in your system will be listed.
Select the network adapter you require by clicking on it. Make sure that you
read the information in the "readme" file on the supplied CD.
Figure 6-2 Configuring the Network Adapter
Note
If the network adapter installed in your system is not displayed, the DLC protocol
required for the network adapter is not installed. In this case, follow the steps
outlined below to install the DLC protocol:
Windows NT – DLC Protocol Installation
● Select Start -> Settings -> Control Panel.
● Click on the "Network" icon.
● Go to the "Protocols" tab and click the "Add" button.
● From the network protocols displayed, select the DLC Protocol.
● Confirm your selection with "OK".
Note
Make sure you have your Windows CD at hand. You may need to reinstall
Windows service packs.