SMC Networks SMC7003USB - Manual (Page 23)

C
ONNECTING THE
S
YSTEM
2-5
Connecting the System
Phone Line Configuration
The EZ Connect ADSL USB Modem supports dual-mode operation for
both full-rate G.dmt and economical G.lite. Your service provider will
attach the outside ADSL line to a data/phone splitter. You can then
connect your phones and computer directly to the splitter as shown below:
Depending on the wiring configuration used in your house, separate wall
jacks may be used for telephone and voice signals. Otherwise, you will
need to connect your phones and PC directly to the splitter.
1. Connect the modem’s ADSL port to the data port on the splitter (or
to an RJ-11 telephone wall jack connected to this port) using standard
telephone cable.
2. Insert the USB cable’s Type-B plug (square end) into the modem’s
USB port.
3. Install the driver best suited for your connection needs as described in
the next chapter.
Voice
Data
Splitter
Residential
Connection
Point [Network
Interface
Device (NID)]
Plain Old
Telephone
System (POTS)
SMC7003USB V.2