Siemens A65 - Manual (Page 9)

©
Sieme
ns
AG
2003, L:\Mobil\R65\
A65_
Puma_v2\am\P
uma_Main.fm
Getting started 8
VAR Langua
ge: a
m
; VAR issue
date: 041104
left page (8) of A65_PUMA am, A31008-H5810-A40-1-4A19 (11.11.2004, 16:23)
Getting started
Using the SIM card/battery
Your phone's display is delivered with a
protective film. Remove this film before get-
ting started . To avoid damage to the dis-
play, the phone should not be used with-
out the front cover. The service provider
supplies you with a SIM card on which all
the important data for your account is
stored. If the SIM card is credit card-sized,
snap out the smaller segment and trim
any rough edges.
Remove the battery cover upwards
1
.
Insert SIM card
2
and push it fully into
the locating slot (make sure the angled
corner is in the correct position
3
). Then
push the retaining catch over the top of
the SIM card
4
.
Insert the battery sideways into the
phone
5
, then press downwards
6
until it engages.
To remove, press the retaining tab
7
then lift the battery out.
Insert the battery cover by the tabs at the
bottom
8
, then press downwards
9
,
until it engages.
Always switch off phone before removing
the battery!
Only 3V SIM cards are supported. Please
contact your service provider if you have
an older card.
Functions without SIM card p. 10.
Charging the battery
The battery is not supplied fully charged.
Plug the charger cable into the bottom of
the phone, plug the power supply unit
into a mains power socket and charge for
at least two hours. The power supply unit
will become hot after extended use. This
is normal and is not dangerous.
1
2
4
3
6
7
5
8
9