Siemens A65 - Manual (Page 10)

©
Siem
ens AG
2003, L
:\Mobi
l\R65
\A65
_Puma_v
2\a
m
\Puma_Main.f
m
9 Switching on/off, PIN
VAR Langua
ge: a
m
; VAR issue
date: 041104
left page (9) of A65_PUMA am, A31008-H5810-A40-1-4A19 (11.11.2004, 16:23)
Display when charging is in progress
h
Charging time
An empty battery is fully charged after
about 2 hours. Charging is only possible
within a temperature range of +5 °C to
+40 °C. If the temperature rises/falls 5 °C
above/below this, the charge symbol flash-
es a warning. The voltage specified on the
power supply unit must not be exceeded.
Charge icon not visible
If the battery was fully discharged, the
charging symbol will not be immediately
visible on connection to the power supply
unit. It will appear after up to two hours.
In this case the battery is fully charged af-
ter 3 - 4 hours.
Only use the power supply unit provided!
Display while in service
Charge level display during operation
(empty-full):
a d g
A beep sounds when the battery is nearly
empty. The charge level of the battery is
displayed correctly only after uninterrupt-
ed charging/discharging. You should
therefore not remove the battery unnecessar-
ily and where possible not interrupt charg-
ing prematurely .
Switching on/off, PIN
Turning the phone on/off
Press and hold the On/Off/End key
B
to
switch on or off.
Enter PIN
The SIM card can be protected with a 4- to
8-digit PIN.
Enter the PIN using the number keys. The
characters **** appear to ensure nobody
can read your PIN on the display. Correct
errors with §Clear§ .
Confirm your input with §OK§ . Logging on
to the network will take a few seconds.
Switching on your phone for the
first time
Time/date
The clock must be set to the right time
once at start-up.
Press
§Yes§ . First enter the date (day/month/
year), then the time (24 hours, including
seconds). Press §OK§ . The time and date
are updated.
If the battery is removed for longer than
30 seconds, the clock must be reset.
Time zones
Specify your current time zone.
Select the desired time zone from the list
with
F
. Apply it with §Set§ .
Strong reception signal
_
Strong receive signal.
^
A weak signal reduces the call-
quality and may lead to loss of
the connection. Change your
location.