Sharp Electronic Organizer YO-270 - Manual (Page 3)

1
Using the Organizer for the First Time
Be sure to perform the following operations before using the Organizer
for the first time.
1. Pull out the battery insulation sheets
from the battery compartment.
The Organizer starts operation.
(The battery insulation sheets were
inserted at the factory to prevent battery
wear.)
2. Press the RESET switch.
A message, “CLEAR ALL DATA OK?” is displayed.
3. Use j or l to select “Yes” and press x.
The message will appear as "Do you really want to initialize the
organizer's memory?"
4. Select “Yes” using j or l and press x.
The Organizer is now initialized. Proceed to set the date and time of
the clock (Refer to page 6).
Note
• Press the RESET switch with a ball-point pen or similar object.
Do not use an object with a breakable or sharp tip.
If a malfunction occurs under abnormal conditions
If the organizer is subjected to strong extraneous electrical noise or
shock during use, on rare occasions, all the functions will not work
properly and data may be displayed incorrectly. In such cases, follow
the procedures as shown below.
1. Press RESET.
2. When a message, "CLEAR ALL DATA OK?" is displayed, select "No"
and press x.
If the first procedure doesn't work, follow the next procedure to
initialize the organizer's memory. In this case, all the stored data will
be deleted.
1. Press RESET.
2. When a message, "CLEAR ALL DATA OK?" is displayed, select
"Yes" and press x.