Sharp Electronic Organizer YO-270 - Manual (Page 28)

26
Before You Begin
Connecting Your Organizer to a PC
1. Turn off your PC and the Organizer.
2. Connect the standard 9-pin connector of the PC interface cable to a
COM port on your PC.
• Using a 25-pin connector instead of the standard 9-pin connector
requires an additional adaptor. (Commercially available.)
3. Connect the other end of the PC Interface Cable to the PC interface
connector located on the left side of the Organizer.
Installing
1. Insert the PC Interface Software disk into your disk drive.
2. Click on the Windows [Start] button and then click [Run].
3. Type in a:\Setup.exe and click on [OK].
• Type in your disk drive name (a:\ in this example).
4. Follow the on-screen instructions.
The software is installed into the following location and can be
accessed in the following directory:
C:\Program Files\Sharp YOZQ-270\
Application:
[Start]
➠ [Program] ➠ [Sharp YOZQ-270] ➠ [EO-Utility]
ReadMe:
[Start]
➠ [Program] ➠ [Sharp YOZQ-270] ➠ [ReadMe]
You are recommended not to change the default folder name:
[Sharp YOZQ-270].
5. Click [Finish].
Note:
• For Windows 2000, install the software after logging on authorized as
system administrator.
PC Interface Cable