Smeg PX140 - Manual (Page 12)

Instructions for the User
30
7. Using the hob
Check that the burners, flame diffuser rings and
pan stands are fitted correctly.
The projections
A on the flame diffuser rings
must be fitted into the recesses B in the burner.
The holes C in the burner must mate with the
ignition plugs and thermocouples D on the hob.
7.1 Fitting the Pan Stands
The pan stands are supplied dismantled from the hob. To place each pan stand on its
burner correctly, follow the instructions provided below:
The ends of the feet of each pan stand carry
silicone rubber pads with holes which must be
fitted onto the fixing pins provided on the hob.
Each pan stand will only fit onto its own burner.
To ensure correct positioning, each pan stand
has a different recess (as shown here) which
will fit over the projection on the corresponding
flame diffuser ring.
Take great care to fit the correct pan stand on
each burner. After the pan stand is fitted its feet
must rest on the hob and not be suspended
above it. To fit the pan stand, first align it with the fixing
pin (1) and then lower it into place on the
hob, taking care that it fits over the flame
diffuser ring correctly (2).