Sears Diehard Portable Power 1150 28.71988 - Manual (Page 8)

• 7 •
NOTE: To prevent overheating, the compressor has built-in thermal protection that
will turn the compressor off before it overheats. If the compressor shuts off, wait a few
minutes and it will automatically restart when the compressor cools.
NOTE: The air compressor is rated for 150 PSI.
Estimated Time for Inflating
Vehicle Tires 13" to 16" 6 to 24 minutes
Bike Tire 1 to 3 minutes
Sports Balls 30 seconds
These times are approximate; use the air compressor gauge to ensure the proper
pressure has been reached. Do not overinflate.
Using the Inflator
8.7
Risk of explosion.
Read instructions of the product being inflated before using the inflator. Avoid
overinflation, do not exceed the manufacturer’s recommended pressures. Do
not leave the inflator unattended during use.
Ensure that the battery clips are securely on the storage holders. 1.
Attach the corrugated hose with end adapter to the high-flow inflator port 2.
located near the inflator ON/OFF switch on the back of the jump starter.
The main accessory adapter attached to the corrugated hose accommodates up to 4 3.
sizes. If another size is needed, an additional adapter can be attached to the end of
the main accessory adapter.
Insert the adapter into the product to be inflated.
4.
Push the Inflator switch to the ON position and inflate the product. 5.
When product is inflated to the desired level, push the Inflator switch to the OFF 6.
position and remove the adapter.
Estimated Time for Inflating
24" Beach Ball 1 to 3 minutes
Pool Raft 4 to 6 minutes
Queen-size Air Mattress 4 to 8 minutes
2 Person Boat 8 to 10 minutes
Times are estimates and will vary depending on size and product features.
Using the Deflator
8.8
Ensure that the battery clips are securely on the storage holders. 1.
Attach the corrugated hose with the end adapter to the high-flow deflator port, which 2.
is located on the side of the jump starter.
The main accessory adapter attached to the corrugated hose accommodates up to 4
3.
sizes. If another size is needed, an additional adapter can be attached to the end of
the main accessory adapter.
Insert the adapter into the item to be deflated.
4.
Push the Inflator switch to the ON position and deflate the item. 5.
When the product is deflated to the desired level, push the Inflator switch to the OFF 6.
position and remove the adapter.
Before Using the Inverter 8.9
Important Safety Instructions:
Keep the jump starter well ventilated in order to properly disperse heat generated 1.
while it is in use. Make sure there are several inches of clearance around the top and
sides, and do not block the vents on the back of the jump starter.
Make sure the jump starter is not close to any potential source of flammable fumes,
2.
gases or clothing.