Sears Diehard Portable Power 1150 28.71988 - Manual (Page 5)

• 4 •
ASSEMBLY INSTRUCTIONS 5.
Remove all cord wraps and uncoil the cables prior to using the jump starter.
FEATURES
6.
jump Start On/Off switch 1.
Inverter/Compressor switch 2.
Digital Display 3.
Plastic lens cover 4.
(2) Light bulbs 5.
(2) 12V DC power outlets 6.
(2) 110V AC household 7.
power outlets.
USB port
8.
Power Switch ( 9. Light/Display)
Air compressor gauge 10.
Air compressor hose 11.
Air compressor accessory bag 12.
Air compressor ball inflation 13.
adapter
(2) Air compressor
14.
miscellaneous inflation adapters
ON/O
15. FF inflator/deflator switch
High-flow inflator port 16.
Inflator/deflator hose end adapter 17.
High-flow deflator port 18.
Inflator/deflator hose 19.
(2) Cables with clamps 20.
(3) Inflator/deflator hose 21.
device adapters
Wall Charger (not shown)
22.
Charger Port 23.
Replaceable Battery (not shown) 24.
1
2
3
4
5
6
7
8
9
21
10
18
16 17
15
19 13 14 12
11
20
23
CHARGING THE INTERNAL BATTERY OF THE JUMP STARTER 7.
IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH USE
AND EvERY 30 DAYS TO KEEP THE JUMP STARTER’S INTERNAL BATTERY
FULLY CHARGED.
To check the internal battery’s charge status, toggle the Light/Display switch to the
7.1
DISPLAY position. The Digital Display will show the battery’s percent of charge. Charge
the internal battery if the display shows it is under 100%.
NOTE: The internal battery’s percent of charge is most accurate when the jump starter
has been disconnected from all devices and charging sources for a few hours.
Charging the Internal Battery using the Included Wall Charger.
7.2
To charge, plug the included wall charger into the charger port on the back of the 1.
jump starter.
Plug the wall charger into a 120V AC electrical wall outlet.
2.
While the jump starter is charging, the battery’s percent of charge will be displayed. 3.
When the internal battery is fully charged, the display will show 100. Complete
charging may take up to 72 hours. The jump starter is then ready to use.