Shark S1209 - Manual (Page 9)

CONSIGNES D’UTILISATION OPERATING INSTRUCTIONS
Pose de l’étrangleur
1. Placez l’étrangleur dans la fente
située à l’arrière de l’aspirateur (fig. 5).
2. À l’aide d’un tournevis Philips et la vis
fournie, attachez l’étrangleur à
l’aspirateur (fig. 6).
Motor Thermostat
• The dust cup container
can be washed in
lukewarm water.
• Do not use strong
detergents.
• Ensure that the dust
cup container is fully
dry before putting back
on the vacuum cleaner.
(Fig. 21) Do not wash in
dishwasher.
Fig. 21
Important: This unit is equipped
with a motor protective thermostat. If
for some reason the vacuum cleaner
should overheat, the thermostat will
automatically turn the unit off. Should
this occur:
• Push the On/Off button once.
• Disconnect the plug from the
power source.
• Check the source of overheating
problem. (i.e. clogged hose or
filter)
• If clogged hose or filter is found,
unclog the hose and replace the
filters.
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for
45 minutes, plug in the cleaner
and push the On/Off button. The
vacuum should start again.
• If the vacuum still does not start,
contact customer service at
1 (800) 798-7398.
7
Cleaning the Pre-Motor Filters
1. Underneath the dust cup container,
are two pre-motor filters. (Fig. 19)
2. One is small and it fits into the air inlet
pipe.
3. To remove, just lift out.
4. To remove the second pre-motor filter,
twist the pre-motor filter cover, lift the
cover out and remove the second pre-
motor filter. (Fig. 19)
Pre-Motor
Filter
Cover
Fig. 19
Fig. 20
Warning: To reduce the risk of electric
shock, the power cord must be
disconnected before removing the dust cup,
HEPA-Type filter,changing the filters or
performing maintenance/trouble shooting
checks.
Cleaning the HEPA-Type Filter
Frame
1. Before replacing the HEPA-Type
filter in the HEPA-Type Filter
frame, you can
(should) rinse
the frame in