Star Manufacturing LC-4522 - Manual (Page 36)

Switch 7: Not Used
EDS Mode Settings 33
BANK C
Switches 1,2: Multi-Part Mode
Specifies whether the printer’s Multi -Part Mode is enabled (ON, OFF) or disabled
(OFF,ON). When the Multi-Part Mode is enabled, the impact of the print head
is increased, but head life is decreased. Enable the Multi -Part Mode when
printing on four to five-ply paper. Disable the Multi -Part Mode when printing
on 1 to 3 -ply paper.
Both switches turns on, Multi-Part Mode is selected by the adjust-lever position when
the position is set to more than 4.
Switch 3: Auto Tear off (Long)
Specifies whether the printer’s auto tear-off (long) feature (page 24) is enabled
(OFF) or disabled (ON). Note that this setting controls the application
software’s tear-off function only. It does not affect the manual tear-off function
that is performed using the control panel buttons.
The manual tear-off function is always enabled.
Switch 4: Skip over perforation (Tractor mode only)
Specifies whether the printer’s skip over perforation feature is enabled
(OFF) or disabled (ON). When skip over perforation is enable, printer
makes 1 -inch bottom margin automatically.
Switch 5: FF command selection (Friction mode only)
Turn off this switch, FF command performs as paper eject command.
Switch 6: Paper eject at Power ON (Friction mode only)
Turn off t his switch, Printer performs a paper eject operation at power on.
Switch 7: Line Spacing
Selects 1/6-inch (ON) or 1/8 -inch (OFF) spacing between lines.