Star Manufacturing LC-4522 - Manual (Page 16)

Loading fanfold paper 13
Note:
You can also completely remove the rear cover by simply pulling it away from
the back of the printer after you open it.
Caution!
The metal edge of the cover is rather sharp. Take care to avoid injuring your
hands when handling it.
o Pass the fanfold paper through the space between the printer case and the
rear cover.
o Unlock the two tractor covers by pulling their gray levers up, and slide
them so they are aligned approximately with the holes on the sides of the
paper. Also move the center paper support so that it is approximately
halfway between the two tractors.
o Open the covers of both tractors and insert the paper so the tractor pins fit.
o Close the tractor covers. At this point you can make final adjustments to the
paper position by releasing the gray levers and moving the tractors. The
paper should lie flat with no buckling or bulging (tractors too close) or no
stretching or elongation of the holes (tractors too far apart). After making
these adjustments, be sure that you re-lock the tractors by pushing the gray
levers back into their original positions.