Sharp UX-A1000 - Manual (Page 20)

Installing the Print Cartridge
18
2
Open the print compartment cover.
•
Press as shown and pull the cover
toward you.
3
Remove only the tape from the the new
cartridge.
•
Important: Make sure you remove all
of the tape.
•
CAUTION! DO NOT touch the gold
contact area of the cartridge.
4
Make sure the cartridge holder is
between the “CARTRIDGE EXCHANGE
AREA” arrows on the label, and then
pull the green lever and open the
cartridge holder cover.
•
If you are replacing the cartridge,
remove the old cartridge. If you are
going to use the old cartridge again,
place it in an air-tight container.
•
CAUTION! DO NOT touch the contact
area inside the carriage carrier.
Note: If the print compartment cover is left
open for approximately 30 minutes with a
cartridge installed, the cartridge will
automatically return to its home position. To
make the cartridge return to the CARTRIDGE
EXCHANGE AREA when this has happened,
close the cover and then open it again.
all.book Page 18 Wednesday, November 12, 2003 9:50 AM