Woodstock SHOP FOX M1014 - Manual (Page 24)

-22-
M1014 7" x 12" Metal Cutting Bandsaw
M
A
INTE
N
A
N
CE
OPERATIONS
General
DO NOT investigate problems or adjust
the Bandsaw while it is running. Wait
until the machine is turned OFF,
unplugged, and all working parts
have come to a complete stop before
proceeding!
The Model M1014 will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed
incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary
knowledge and skills to operate this machine. If at any
time you are experiencing difficulties performing any
operation, stop using the machine!
If you are an inexperienced operator, we strongly rec-
ommend that you read books, trade articles, or seek
training from an experienced bandsaw operator before
performing any unfamiliar operations. Above all, your
safety should come first!
Always wear safety glasses when
operating the 7" x 12" Metal Cutting
Bandsaw. Failure to comply may result
in serious personal injury.
READ and understand this entire instruc-
tion manual before using this machine.
Serious personal injury may occur if
safety and operational information is not
understood and followed. DO NOT risk
your safety by not reading!
Operation
B efore making cuts to the workpiece, it is important
that all safety precautions and bandsaw adjustments are
addressed. For vertical cutting, refer to Vertical Cutting
Table on Page 16 for table installation steps.
For basic cutting operations, do t hese steps:
1. C heck oil level and top it off if required (refer
to Lubrication on Page 29 for instructions).
2. Select and install the required blade (refer to
Blade Selection on Page 24 for blade TPI).
3. Select the required cutting speed, (refer
to Changing Cutting Speed on Page 19 for
instructions).
4. Make sure cutting fluid reservoir is full and the
fluid is correct for the type of blade and material
to be cut (refer to Cutting Fluid on Page 26 for
instructions).
5. Raise and lock the headstock, so the blade is
approximately 3" from the workpiece, and open the
vise to accept the workpiece.
NOTICE: NEVER let the saw blade rest on the workpiece
without the saw running. Otherwise, you will
permanently damage the saw blade !