Woodstock SHOP FOX M1014 - Manual (Page 17)

-15-
M1014 7" x 12" Metal Cutting Bandsaw
SE
T
U
P
Pulley Cover
Figure 18. Installing the bearing guard.
Figure 19. Positioning the pulley cover.
Figure 20. Securing the pulley cover.
When opened, the pulley cover gives you the ability to
change the pulley ratio so the bandsaw can cut at one of
four speeds.
To install the pulley cover, do these steps:
1. UNPLUG THE BANDSAW POWER CORD!
2. Snap the bearing guard into the pulley cover (see
Figure 18).
3. Position and rotate the pulley cover mounting plate
onto the motor as shown in Figure 19.
4. Install the pulley cover mounting screws, as shown
in Figure 20.
5. Make sure the pulley ratio will produce the speed
that you want.
• If the speed needs to be changed, complete the
Changing Cutting Speed procedure on Page 19.
6. Install the belt and make sure it has 1/4" deflection
when pressed.
• If the belt is out of adjustment, complete the
Belt Tension procedure on Page 18.
ENTANGLEMENT HAZARD!
MAKE SURE the bandsaw is
unplugged before proceeding!
Otherwise, severe injury may
occur.