Handle, wheels, and feet – Woodstock SHOP FOX M1014 User Manual

Page 15

-13-

M1014 7" x 12" Metal Cutting Bandsaw

GET assistance when lifting this

machine. Otherwise, you can

severely injure yourself!

To install the handle, wheels, and feet, do these

steps:

1. With the help of an assistant, support the bandsaw

on wooden blocks approximately 4" from the ground

so you have room to install the handle, wheels, and

feet.

2. Align the handle mounting holes with the bandsaw

holes, and install the

5/16"-18 x 1-1/4" hex bolts,

washers, and nuts

(see

Figure 12).

3. Insert the axle into the cabinet, and slide the

wheels onto the axles.

4. Slide the two 5/8" flat washers onto the axles, and

install the two cotter pins (see

Figure 13).

5. Thread one 3/8"-18 hex nut and install one 3/8"

washer onto each threaded foot shaft (see

Figure

14).

6. Thread the foot shafts into the underside of the

bandsaw cabinet (see

Figure 14).

7. With the help of an assistant, remove the bandsaw

from the blocks.

8. Turn the feet until the bandsaw is level, and tighten

the hex nut to lock the feet in place.

Handle, Wheels, and Feet

Figure 12. Installed handle.

Figure 13. Installed wheel.

Figure 14. Installed feet.

Hex Nut

Here

Flat

Washer

Here

Hex

Bolt and

Washer