Woodstock SHOP FOX W1712 - Manual (Page 29)

OPERATIONS
-17-
The purpose of a test run is to identify any
unusual noises and vibrations, as well as to
confirm that the machine is performing as
intended.
To test run the Model W1712, do these steps:
1. Make sure all guards are in place.
2. Make sure that the ON/OFF switch is in the
“OFF” position before connecting the
machine to power.
3. Pull the power switch up to start the
sander. Once the sander is running, listen
for any unusual noises. The machine should
run smoothly with little or no vibrations.
• If there are any unusual noises or vibra-
tions, STOP the sander immediately by
pushing the paddle switch down.
4. Unplug the sander and investigate the
source of the noise or vibration. DO NOT
make any adjustments to the sander while
it is plugged in. The sander should not be
run any further until the problems are cor-
rected.
This machine produces
sawdust that may cause
allergic reactions or res-
piratory problems. Wear
a respirator in addition
to using a dust collector.
THIS MACHINE creates
sawdust. Always wear
safety glasses or a face
shield during all sanding
operations.
KEEP loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Test Run
OPERATIONS