Shindaiwa X7502864301 - Manual (Page 6)

6
An Emission Control Label is located on the unit. (This is an EXAMPLE ONLY; information on label varies by en-
gine FAMILY).
PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)
The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine
emissions output meets applicable emissions regulations, provided that approved maintenance procedures are
followed as listed in the Maintenance Section of this manual.
Emission Control (Exhaust & Evaporative)
EPA 2010 and Later and/or C.A.R.B. TIER III
The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the
fuel tank the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission
may be applicable to California models only.
WARNING!
Do not make unauthorized modifications or alterations to this machine or any of its components or accessories.
Unit Description
IMPORTANT!
The terms “left,” “left-hand,” and “LH”; “right,” “right-hand,” and “RH” ; “front” and “rear” refer to directions as
viewed by the operator during normal operation of this product.
Familiarize yourself with your machine and its various components. Understanding your machine helps ensure top performance,
long service life, and safer operation.
Prior to use
Before using this product, please make sure you have all the components required for a complete unit:
Unit assembly
■
Cutter blade cover
■
Carefully inspect all components for damage.
Figure 3
Air Cleaner
Cover
Gearcase
Choke
Ignition
Switch
Fuel Cap
Throttle
Trigger
Front Handle
Rear Handle
Guide Bar
Cutter
Recoil
Starter
Muffler
Protector
Fuel Tank
Kit with this manual and tool kit for routine maintenance.
■
Blade Cover