Long term storage – Shindaiwa X7502864301 User Manual

Page 18

The engine

must return to idle speed whenever the throttle lever is released. Idle

speed is adjustable, and

must be set low enough to permit the engine clutch to

disengage the cutters.

WARNING!

The cutters must NEVER engage at engine idle speeds! If the idle speed can-

not be adjusted by the above procedure, return the trimmer to your Shindaiwa

dealer for inspection.

Idle Speed Adjustment

Start the engine, and then allow it to idle 2–3 minutes until warm.

If the cutters move when the engine is at idle, reduce idle speed by turning the

idle adjustment screw counterclockwise.
If a tachometer is available, adjust idle. Check Specifications page for correct

idle speed.
Carburetor fuel mixture adjustments are preset at the factory and cannot be

adjusted or serviced in the field.

Idle Adjustment

Screw

Figure 10

Long Term Storage

Whenever the unit will not be used for 30

days or longer, use the following proce-

dures to prepare it for storage:

Clean external parts thoroughly and

■

apply a light coating of oil to all metal

surfaces.
Drain all the fuel from the carburetor

■

and the fuel tank.

To do so:

Prime the primer bulb until no more

fuel is passing through.
Start and run the engine until it stops

running.
Repeat steps 1 and 2 until the engine

will no longer start.

Remove the spark plug and pour

■

about 1/4 oz. of engine oil into the

cylinder through the spark plug hole.

Slowly pull the recoil starter 2 or

3 times so oil will evenly coat the

interior of the engine. Reinstall the

spark plug.
Before storing the unit, repair or

■

replace any worn or damaged parts.
Remove the air cleaner element

■

from the carburetor and clean it thor-

oughly with soap and water. Let dry

and reassemble the element.
Store the unit in a clean, dust-free

■

area.

CAUTION!
Gasoline stored in the carburetor

for extended periods can cause

hard starting, and could also lead to

increased service and maintenance

costs.

IMPORTANT!

All stored fuels should be stabilized with

a fuel stabilizer such as STA-BIL™.

NOTE:

Damage resulting from stale or contami-

nated fuel is not covered by the Shindaiwa

warranty policy.

This manual is related to the following products:

DH254