Southbend SB1017 - Manual (Page 14)

-12-
For Machines Mfg. Since 8/09 Model SB1017 P R E P A R A T I O N
Inventory
The items listed below are optional components
and are not required for bandsaw operations.
Their installation and use is covered in
Operation, beginning on Page 19. Parts A and
D are required for Vertical Cutting (Page 30).
Description Qty
M. Table (Vertical Operation) .............................1
N. Work Stop .......................................................1
O. Work Stop Rod ...............................................1
P. Table Support (Vertical Operation) ..............1
Figure 6. Optional components.
O
N
P
M
Figure 5. Stand components.
K
J
L
I
Description (Figure 5) Qty
I. Rear Panel ......................................................1
J. Right Side Panel ............................................1
K. Front Panel .....................................................1
L. Left Side Panel ...............................................1
Description (Figure 4) Qty
A. Handle ............................................................1
B. Axle .................................................................1
C. Wheels ............................................................2
D. Leveling Feet ..................................................2
E. Handwheel .....................................................1
F Handwheel Handle ........................................1
G. Pulley Cover ...................................................1
H. V-Belt ..............................................................1
Figure 4. Small components.
C
D
E
B
A
F
G
H
Hardware (Not Shown) Qty
• Hex Nut 1 ⁄
4
"-20 (Vertical Operation) .............1
• Flat Head Screw 1 ⁄
4
"-20 x 1 ⁄
2
"
(Vertical Operation) .......................................1
• Hex Wrench 4mm ..........................................1
• Hex Bolt M8-1.25 x 15 .................................21
• Hex Nut M8-1.25 ..........................................19
• Flat Washer 8mm ........................................40
• Hex Bolt M12-1.75 x 25 ................................4
• Flat Washer 12mm ........................................5
• Knob M6-1 x 15 ..............................................1
• Cotter Pins .....................................................2
Unpacking
This item was carefully packaged to prevent
damage during transport. If you discover any
damage, please immediately call Customer
Service at (360) 734-1540 for advice. You may
need to file a freight claim, so save the containers
and all packing materials for possible inspection
by the carrier or its agent.