Woodstock W1752 - Manual (Page 21)

-19-
W1752 Owner's Manual (Mfg. 1/07+)
O
PE
R
ATIO
NS
Installing/Removing
Faceplate
The faceplate can be installed only if the spur center has
been removed from the headstock spindle. The knock-out
bar is included with the lathe for installing and removing
the faceplate.
To install the faceplate, do these steps:
1. UNPLUG LATHE FROM POWER!
2. Remove the spur center (see Page 18).
3. Thread the faceplate onto the headstock spindle.
4. Using the knock-out bar, hand tighten the faceplate
as shown in Figure 13.
Note: Reverse Steps 3-4 to remove the faceplate.
To mount a workpiece to your faceplate, refer to Page
23.
Figure 13. Tightening faceplate.