Silex technology 802.11a/b/g SDIO Module SX-SDWAG - Manual (Page 13)

Installation Silex Page 9
Revision A-2
Chapter 3
Installation
Installation Requirements
The SX-SDWAG must be installed in a device that contains a 9-pin SDIO slot.
The SX-SDWAG has FCC modular approval, which can eliminate the need for you obtain FCC Part 15
Subpart C and E (intentional radiation) approvals for your device. In order to use this FCC modular
approval for the SX-SDWAG, you must:
1. Include “Contains FCC ID: N6C-SXSDWAG” on the label of your device.
2. Use the Silex dipole antenna (refer to appendix A) or an equivalent dipole antenna with equal or
lower gain.
3. Use the special Silex antenna cable (includes ferrites for additional EMI suppression; refer to
Appendix A)
If you do not follow the above instructions, then it is your responsibility to obtain the necessary FCC
approvals.
Installation Procedure
To install the SX-SDWAG:
1. Be sure to use the proper antistatic handling techniques.
2. Insert the SX-SDWAG into an available SDIO slot in your device. Make sure that it is securely
seated.
3. Connect one end of the antenna cable to the main antenna connector on the SX-SDWAG (see
figure 2). If you are using a diversity antenna configuration, connect one end of the second
antenna cable to the secondary antenna on the SX-SDWAG.