Sim2 Multimedia HT 250 - Manual (Page 23)

HT 200/250
25
ENGLISH
Incomplete image along borders (vertical and horizontal): - Compare compatibility of video/graphic signals and tech-
nical specifications of your projector.
- Press Auto (on your remote or key-pad) to execute
automatic adjustments.
- Adjust the horizontal and vertical position of projected
image by selecting Position on the Image
Adjustments menu.
- Adjust the width and height of image, selecting Aspect
in the Image Adjustments menu.
Image too dark, too pale or unnaturally coloured: - Verify compatibility of video/graphic signals with technical
specifications of your projector.
- Go to Picture menu, select and regulate any of the following,
accordingly: Contrast, Brightness, Color, and Tint.
- If necessary, reset the Color Temperature and Gamma
Correction (found on the Image Adjustments menu /
Advanced Settings menu).
Graphic image with poor quality vertical detail: - Verify compatibility of video/graphic signals with technical
specifications of your projector.
- Press Auto (on your remote or key-pad) to execute au-
tomatic adjustments.
- Adjust Frequency and Phase parameters, found in the
Image Adjustments menu, to optimise vertical detail
of the projected image.
Video Image showing colour misalignment on - Verify compatibility of video/graphic signals with technical
vertical details: specifications of your projector.
- Adjust Y/C Delay settings in the Image Adjustments /
Advanced Settings to reduce colour misalignment. For
best results use an external colour bar test pattern
source.
Remote control does not work: - Check the batteries and for correct polarity.
- Ensure that the area between the infrared sensor (front
of projector) and the remote control is free of obstruction.
- Ensure that infrared sensors (front and rear of projector)
are not exposed to intense light levels.