beautypg.com

Sherwood V-768 User Manual

Page 42

background image

43

If a fault occurs, run through the table below before taking your unit for repair.
If the fault persists, attempt to solve it by switching the unit off and on again. If this fails to resolve the situation, consult your
dealer. Under no circumstances should you repair the unit yourself as this will invalidate the guarantee!

PROBLEM

POSSIBLE CAUSE

REMEDY

No power

No playback

Malfunction

No picture

Noisy or distorted
picture

Abnormal picture

Slight pause of
picture

No sound

Noisy or distorted
sound

Remote control unit
does not operate.

• The AC input cord is disconnected.
• Poor connection at AC wall outlet or the outlet

is inactive.

• The disc is loaded upside down.
• The disc is not playable.
• The disc is dirty.
• The rating level is not set correctly.

• The symbol about invalid operation is displayed.

• The disc is scratched or dirty badly.

• The video cords are disconnected.
• The incorrect selection of input source on the

TV.

• The disc is not playable.

• The unit is connected to a VCR directly and the

copyguard function is activated.

• The disc is dirty.
• It is in rapid advance or reverse playback, or in

frame advance or reverse playback.

• The COMPONENT OUT is not set correctly or

the component video output signal is not
selected correctly.

• The layer transition occurs during playback of

DVD Videos recoded in dual-layer format.

• The audio cords are disconnected.
• The speakers are disconnected to the amplifier.
• The incorrect selection of input source on the

amplifier.

• The audio setup is not adjusted correctly.

• The disc is dirty.
• Poor connections.

• Batteries are not loaded or exhausted.
• The remote sensor is obstructed.

• Connect cord securely.
• Check the outlet using a lamp or another

appliance.

• Reload the disc with the printed side up.
• Use a playable disc.
• Clean the disc.
• Set the rating level setting correctly.

(Refer to “SETTING THE CUSTOM SETUP” on
page 37.)

• Adjust the setting correctly.

(Refer to “SYMBOL ABOUT INVALID OPERATION”
on page 13.)

• Press the POWER switch to switch the power

off, press the POWER switch again and then
unload the disc.

• Connect the cords correctly.
• Select the input source correctly.

• Use a playable disc.

• Connect the unit so that the picture signal is

transferred directly to the TV.

• Clean the disc.
• Sometimes a small amount of picture distortion

may appear. This is not malfunction.

• Set the COMPONENT OUT setting correctly or

select the component video output signal
correctly.

(Refer to “SETTING THE VIDEO SETUP” on
page 32 or “CHANGING THE COMPONENT
VIDEO OUTPUT SIGNAL” on page 26.)

• Sometimes slight pause may occur.

This is not malfunction.

• Connect the cords correctly.
• Connect the speakers correctly.
• Select the input source correctly.

• Adjust the audio setup correctly.

(Refer to “SETTING THE AUDIO SETUP” on
page 35.)

• Clean the disc.
• Check the connections and connect all cords

securely.

• Replace the batteries.
• Remove the obstacle.

ENGLISH