Sony CM-B1200 - Manual (Page 16)

16
To use your phone, the power must be turned on. It is preferable
to extend the antenna, since this maximizes signal strength and
minimizes interference.
Extending the antenna
Hold the end of the antenna and pull up until fully extended.
To retract the antenna
Push the antenna down until it is fully retracted.
Turning the power on
Hold down PWR for about one second. A beep sounds and the
phone starts searching for a signal.
When the phone has found a service signal, the standby display
appears. Now the phone is ready to use.
To check the signal strength
The signal strength icon indicates various levels of signal strength. It is best to make calls
when the signal is strong, although calls can be made when the signal strength is weak.
If you are out of the service area
The out-of-service icon ( ) appears, and the phone searches for a
service signal.
If a signal cannot be found, the phone enters power save mode.
It will “wake up” automatically at intervals (based on carrier
network settings) to search for a service signal.
Turning the power off
Hold down PWR for about one second. The following display
appears briefly, then the phone turns off.
Turning the phone on
PWR CLR
SEND END
Looking for
service.....
:Saved #s
:Features
My Phone
12:34P 12/25
:Saved #s
:Features
Strong Weak
Pull up
Looking for
service.....
:Saved #s
:Features
v
POWERING OFF
No Service
available.
Now in power
saving mode.
PWR
B2200/08-17final 3/2/98, 1:15 PM 16