Sherwood R-956 User Manual

Page 15

1 5

Operate the selected component for
playback.

Enter the tone mode.

Select the digital or the analog input
connected as desired.

Each time the MULTI CONTROL knob is rotated,
the tone mode changes as follows:

DIRECT ON: When listening to a pure program

source without the tone effect.

DIRECT OFF: When adjusting the tone for your

taste.

When “DIRECT ON” is selected.
“DIRECT” lights up, meaning the tone direct
function is activated and the sound that bypasses the
tone circuitry will be heard.
To cancel the tone direct function, select “DIRECT
OFF” performing the above steps 7 and 8.
When “DIRECT OFF” is selected.

1) Select the tone mode as desired.

Each time this button is pressed, the mode changes
as follows;

BASS

TREBLE

DIRECT OFF

2) At the desired tone, adjust as desired.

In general, we recommend the bass and the treble to
be set to 0(flat) level.
To complete tone adjustment, repeat the above steps
1) and 2).
Notes:
If the tone display disappears, start from the step 7
again.
Extreme settings of the tone controls at high volume
may damage your speakers.
In DTS or Dolby Digital modes, the tone controls
cannot be adjusted and the tone direct function is
activated automatically .

“DIRECT ON” or “DIRECT OFF” is shown for 5
seconds.

To play back the program sources in surround
sound, refer to “ENJOYING SURROUND
SOUND” on page 19.

Adjust the (overall) volume.

Select the tone mode as desired.

When CD, TAPE MON or VIDEO 1~
VIDEO 4 is selected

Adjusting the tone (bass and treble)

Each time this button is pressed, the corresponding
input is selected as follows;

DIGITAL

ANALOG

To listen to DTS or Dolby Digital program sources
in the 2-CH downmix mode (the stereo mode), the
digital input must be selected. (For details, refer to
“Downmixing into 2 front channels” on page 22.)
When PHONO, TUNER, VIDEO 5 or AUX is
selected as an input source, the analog input is
selected automatically.
Note:
When the selected digital input is not connected or
has no sound, “DIGITAL” flickers indicating the
lack of sound. (refer to “ENJOYING SURROUND
SOUND” on page 19.)

ENGLISH

DIGITAL/ANALOG

TONE MODE

MULTI CONTROL

MASTER VOLUME

DOWN

TUP

AUD

SAT

VOL

VID 4

TUP

P.SCAN

VOL

SLEEP

CH LEVL

HOME THEATER MASTER

RNC-30

PWR

ENTER

PHONO

TUNER TAPE MON

T2 MON

VID SEL

VID 2

VID 3

VID 4

AUX

ROOM 2 SYS DISP

AUD

DVD

AUX

VCR

CBL

SAT

MUTE

CH SEL

T.TONE

D.TIME

D.ADJ

STEREO

AUTO

6.1CH IN

DSP MODE

OSD

VOL