Summit BROTHER HL-630 OPC - Manual (Page 25)

25
Okidata C3000 Series
Okidata OPC Color Cartridge Part # 42126661,
42126660, 42126659, 42126658
OEM Stated Yield: 15,000 All
These machines have a glass fuse that is used to
reset the machine. The fuse is located in the gear
end cap of the cartridge. We have not confirmed this
yet, but we believe that the fuse is the same as the
SF-5100. The fuse must be replaced each cycle.
Okidata C5100 Series
Okidata OPC Color Cartridge Part # 42126604,
42126603, 42126602, 42126601
OEM Stated Yield: 15,000 All
These machines have a glass fuse that is used to
reset the machine. The fuse is located in the gear
end cap of the cartridge. We have not confirmed this
yet, but we believe that the fuse is the same as the
SF-5100. The fuse must be replaced each cycle
Okidata OL-400/800 OPC
Okidata OPC cartridge part # 56106601
OEM Stated Yield: 15,000
Although all of these machines use the same
cartridge, the reset procedures are different.
Reset procedure for the Okidata OL-800 Series
Printers
Turn off the printer
While holding the MENU1/MENU2 button down,
turn the printer back on. Keep holding the button
down until you see "MAINTENANCE MODE" on
the display panel. Release the button.
Press the MENU1/MENU2 button three times. The
display will read "DRUM COUNT RESET".
Press the ENTER/QUIET button. The display will
read "DRUM COUNT RESET RESETTING", then
"INITIALIZING", then "WARMING UP", and
finally "ON LINE". The counter is reset!
Reset procedure for all other OL series Laser
Printers.
Turn the printer off.
Press and hold the RESET button (not the Menu
Reset), and turn the printer on. Hold the button down
until you see "DRUM RESET" on the display.
Release the button.
Run a self-test. Turn the printer off-line and press
the PRINT
FONT/SELF TEST button once and release. The
printer will print out a page with the installed fonts,
and the page count of the printer.
Reset procedure for the "DOC-IT" Document
Processing Systems.
Turn the DOC-IT on, and re-initialize it: either re-
boot the computer, or type DOCIT at the DOS
prompt and press enter.
Press and hold the ENTER key for 3 seconds, when
you release it you should see "Administration" on
the display.
Press the down arrow key until you see: Reset drum
ctr.? YES/NO
Press the left arrow key to move the check mark next
to "YES". Then
Press ENTER.
Press any key to leave the Administration menu.
The counter is reset!