Summit BROTHER HL-630 OPC - Manual (Page 18)

18
E-120 Drum cartridge: With the printer turned on,
open the front door. Press and hold the CANCEL
button until all the lights begin to cycle. Close the
front door. Press the continue button to resume
printing.
Lexmark E220
Lexmark Cartridge Part 12S0300 (Return Program),
12S0400 (Standard)
OEM Stated Yield: 2,500
This system uses a separate toner and drum
cartridge. The “Return program” toner cartridge has
a “Killer Chip” on it that must be replaced each
cycle. On the Standard cartridges the chip is also
present, but the killer part is not active. These
cartridges can be re-manufactured as much as you
want, the chip will not interfere.
Lexmark E23x/24x/33x/34x
Lexmark OLD Toner Cartridge Part #’s 12A8400,
12A8405 (Return Program),
12A8300, 12A8305 (Standard)
OEM Toner Stated Yield: 2,500 (8400,8300)
6,000 (8405, 8305)
Lexmark NEW Toner Cartridge Part #’s 24015SA,
34015HA (Return Program),
24035SA, 24035HA (Standard)
OEM Toner Stated Yield: 2,500 (240 cartridges)
6,000 (340 cartridges)
OEM Drum cartridge 12A8302, Stated drum yield:
30,000
Toner cartridges: The “Return” toner cartridges
have an ARD on a small board located inside the
right end cap of the cartridge. Like other cartridges
in this series, the board for these cartridges has two
contact pads where the machine makes direct
contact. New replacement chips are available now.
On the Non-Prebate cartridges the chip is also
present, but the killer part is not active. The Standard
cartridges can be re-manufactured as much as you
want, the chip will not interfere
. In both cases, the
chips use the new “Overdrive code”. Make sure
your supplier is up to date with the proper code.
There are multiple other printer brands that use this
engine. Some manufacturers have universal chips,
some have individual chips. Make sure you have the
correct ones.
E23x, e33x, and E240 Drum units: With the printer
turned on and in the READY state, open the front
cover. Press and hold the CANCEL button until all
the lights begin flashing up and down. Release the
CANCEL button and close the door.
E340, E342 Drum units: Turn the printer off. With
the printer still off, press and hold the SELECT and
RETURN buttons. While still holding the buttons
down, turn the printer back on. Keep holding them
down until the screen shows PERFORMING SELF
TEST or CONFIG MENU. Release the buttons
when either of these messages are displayed. Press
the left or right arrow buttons until RESET PC CNT
appears on the display. Press the SELECT button.
When the display shows CONFIG MENU again,
turn the printer off. Wait 5 seconds and turn the
printer back on. (Do not hold any buttons down this
time). The counter is reset!
DELL 1700/1710 Drum units: With the printer on,
press and hold the CANCEL button. The counter is
reset when all the LEDs flash in sequence.