Sony PEG-S320 - Manual (Page 123)

123 Chapter3 Exchanging and updating data using a HotSync ® operation
Conducting an IR HotSync operation
You can use the IR (infrared) port of your CLIE handheld to perform an IR
HotSync operation with a computer equipped with an IrDA (Infrared Data
Association) IR port. An IR HotSync operation allows you to perform a
HotSync operation without using the USB cable.
Before you start performing an IR HotSync operation
Check the following:
• Your computer is equipped with an infrared port supporting the IrDA
standards.
• The infrared port of your computer is enabled for Windows use.
To enable the IR port with Windows, see the manual of the computer you
are using or the Windows online help.
• Which port number is allocated to the infrared port.
Check the infrared port number in the Infrared Monitor in the Control
Panel. For information on the Infrared Monitor, see the manual of the
computer you are using or the Windows online help.
Preparing your computer
To perform an IR HotSync operation, you have to allocate a virtual port to
an IR HotSync operation.
1
Click the HotSync icon in the Windows task tray (bottom-
right corner of the taskbar) and then select Local Serial from
the shortcut menu.
2
Click the HotSync icon in the Windows task tray again
and then select Setup from the shortcut menu.
The setup dialog box is displayed.
Advanced HotSync
®
operations
Continued on next page