Seagate Barracuda ST318418N - Manual (Page 67)

Barracuda 36ES2 Product Manual, Rev. B 57
9.5 Synchronous data transfer
9.5.1 Synchronous data transfer periods supported
Table 11 and Section 9.5.2 list Synchronous Data transfer periods supported by the drive. The data transfer
period to be used by the drive and the initiator is established by an exchange of messages during the Message
Phase of operation. See the section on message protocol in the
SCSI Interface Product Manual, part number
75789509.
Table 11: Synchronous data transfer periods
[1] This transfer rate is only allowed when using the LVD interface.
9.5.2 REQ/ACK offset
The maximum value supported by the Barracuda 36ES2 family drives for REQ/ACK offset is 63 (3Fh).
9.6 Physical interface
This section describes the connectors, cables, signals, terminators and bus timing of the DC and SCSI I/O
interface. See Section 9.8 and Section 9.9 for additional terminator information.
Figures 16 and 17 show the locations of the DC power connector, SCSI interface connector, drive select head-
ers, and option select headers.
Details of the physical, electrical and logical characteristics are given in sections following, while the SCSI
operational aspects of Seagate drive interfaces are given in the
SCSI Interface Product Manual, part number
75789509.
9.6.1 DC cable and connector
N and LW model drives receive DC power through a 4 pin connector (see Figures 22 and 23 for pin assign-
ments) mounted at the rear of the main PCBA. Recommended part numbers of the mating connector are listed
below, but equivalent parts may be used.
M (decimal)
Transfer period
(nanoseconds) Transfer rate
(megatransfers/second)
9 12.5 80.0 [1]
10 25 40.0 [1]
12 50 20.0
25 100 10.0
50 200 5.0
Type of cable Connector Contacts (20-14 AWG)
14 AWG MP 1-480424-0 AMP 60619-4 (Loose Piece)
AMP 61117-4 (Strip)