Speco Technologies HT-INTD3 - Manual (Page 15)

Operating your camera -
CAMERA TITLE② Operating your camera - CAMERA TITLE①
③ Press SET button to access the SETUP mode.
④ You can enter up to 15 characters.
a. Move the cursor to character-enter location by using the LEFT
or RIGHT button.
b. Select the desired character by using the UP or DOWN button.
c. Press SET button to confirm the blinking character. The first
character is saved and the cursor in the bottom of the screen
moves to the next position.
d. Repeat above steps until you create the full name you want.
e. Select the position at which the CAMERA TITLE will be located on
the screen.
-Move the cursor to ‘POS’ and press SET button.
-Select the position by using the 4-directional buttons, then press
the SET button to confirm the position.
f. When completed, move the cursor to ‘END’ and press SET button.
8) NEXT PAGE
①
Press the SET button to display the SETUP menu and move the
arrow indicator to ‘NEXT PAGE’ using the UP or DOWN button.
②
SET ‘NEXT PAGE’ to the desired mode using the LEFT or RIGHT
button.
(1) CAMERA TITLE
(2) ① Press the SET button to display the SETUP menu and move the arrow
indicator to ‘CAMERA TITLE’ using the UP or DOWN button.
② SET ‘ON’ using the LEFT or RIGHT button.
● If you make a mistake while entering the name
Move the cursor to ‘CLR’, press ‘SET’ button.
After erasing the character from right to left, correct the character again.
Notes
● If the CAMERA TITLE feature is set to ‘OFF’, the name will not
displayed in the monitor.
Notes
25 26