Seagate 540SL - Manual (Page 11)

Caution. The cable and connector bond is delicate. Pulling the
cable to remove the connector may damage the cable.
Attach an interface connector to the drive. If your interface con-
nector has a key, it will plug into the drive only one way. Make
sure that you do not bend the pins when you attach the cable.
Attach an interface-connector to the hard-disc controller connec-
tor on the motherboard or host adapter (see your system user’s
guide or host adapter user’s guide to determine the location of
pin 1). Make sure that pin 1 is aligned with pin 1 on the drive.
Cable-select installation: If your computer uses cable-select for
connection, refer to its user’s guide to determine which interface
connector is used for the master and which is used for the slave.
2. Attach a power-supply cable to the drive.
Power
cable
Pin 1
Cable
stripe
Figure 3. Attaching cables to the drive
Medalist SL Family Installation Guide, November 1995 9