Sharp UX-B700 - Manual (Page 58)

Sending a Fax From Memory
56
Memory transmission
You can also send a fax through memory when sending to a single
destination. This is convenient when sending to destinations where the line is
often busy, as it saves you from waiting to pick up the original document and
frees the feeder for other operations.
To send a fax through memory, load the document, press , and then
dial using one of the following methods:
♦
Press the number keys to enter the fax number and then press .
♦
Press a Rapid Key and then press .
♦
Press , enter a 2-digit Speed Dial number, and press .
♦
Press repeatedly to select an auto-dial number and then press .
♦
Press once to select the last number dialed and then press
.
START/
MEMORY
START/
MEMORY
START/
MEMORY
SPEED DIAL
START/
MEMORY
START/
MEMORY
REDIAL
Z
START/
MEMORY
If the memory becomes full...
If the memory becomes full while the document is being scanned, MEMORY
IS FULL will appear in the display.
♦
Press if you want to transmit the pages which have been stored up
to that point in memory. The remaining pages will be ejected from the
feeder. After transmission, the memory will be cleared and you can transmit
the remaining pages. You will also need to transmit the page which was
being scanned when the memory filled up.
♦
Press if you want to cancel the entire transmission.
START/
MEMORY
STOP