Sharp UX-B700 - Manual (Page 114)

112
S H A R P
Revised date: .
Issued date :Sep.19.2002
MATERIAL SAFETY DATA SHEET (2/3)
MSDS No. B-1028
Section 5. First Aid Measures
Inhalation: Remove to fresh air. Seek medical attention if breathing becomes difficult.
Ingestion: Immediately rinse mouth out with plenty of water. If within 30 minutes after ingestion, give
victim a small glass of water or milk (NEVER give anything by mouth to an unconscious
person). Contact physician or poison center. Do not induce vomiting unless instructed to
do so by a physician or poison center.
Skin Contact: Remove contaminated clothing. Flush affected area with water. Seek medical attention
if irritation develops and persists.
Eye Contact: Flush immediately with plenty of water. Remove contact lenses and continue flushing for at least
15 minutes. Seek medical attention if irritation develops and persists.
Section 6. Fire Fighting Measures
Flash Point: Not applicable
Flammability Limits(%): Not applicable
Extinguishing Media:
Water, foam, carbon, dioxide or dry chemical.
Fire fighting: Fire may produce small amounts of hazardous decomposition products such as
carbon dioxide, carbon monoxide, and unidentified organics. NIOSH approved
self-contained breathing apparatus may be required if a large volume of ink is
involved.
Fire and Explosion Hazard: No unusual fire or explosion hazards are known for this product.
Hazardous Combustion Products: Oxides of carbon, organic acids, low molecular weight organics.
Section 7. Accidental Release Measures
Occupational Spill: Absorb small ink spills with cloth or paper towels or other suitable material.
Place in a container for disposal. For large spills, dike around spill with absorbent
material.
Transfer contaminated diking material to separate, suitable containers for recovery
or disposal.
Ventilate area and wash spill site after material pickup is complete.
Unless specifically permitted, keep waste out of sewers, watershed and waterways.
Section 8. Handling and Storage
STORE IN COOL, DRY PLACE
Section 9. Exposure Control/Personal Protection
Ventilation: Mechanical room ventilation
Eye Protection: None needed for intended use in printer.
Protective Clothing: None needed for intended use in printer.
Gloves: None needed for intended use in printer.
Section 10. Physical Chemical Characteristics
Description: Black liquid with faint odor. Freezing Point: Approx. -12 to -150 ° C
Pressurized: No pH: 7.0-8.5
Water Solubility: Fully Miscible Percent Volatile: Approx. 18.7
Evaporation Rate Specific Gravity: Approx. 1.0 mg/I
(Butylacetate=1): Approx. 3.5 Vapor Density (Air=1): Approx. 1.6
Section 11. Stability and Reactivity
Stability: None known.
Incompatibilities: None known.
Thermal decomposition products: Oxides of carbon, acid gases, low molecular weight organics.
Hazardous polymerization: This product will not polymerize.