Shear bolt or slip clutch driveline installation, Assembly, Assembl y – Servis-Rhino 00781400C User Manual

Page 98

Text mode
Original mode

ASSEMBLY

172 02/11

Assembly Section 3-6

ASSEMBL

SHEAR BOLT or SLIP CLUTCH DRIVELINE INSTALLATION

Attach rear driveline of U-Joint to input shaft on gearbox, install snap ring in groove on input shaft.

NOTE: Check that Snap Ring is properly seated in groove. This snap ring retains driveline when shear bolt
shears. Install Grad 2 (Only) shear bolt 1/2” x 3-1/2”. Use of a stronger shear bolt other than Grade 2, will result
in driveline failure and will void warranty. Figure Asmp-R-0043

Attach slip clutch driveline to input shaft on gearbox with Grade 8 Bolt Figure Asm-R-0073 & AsmP-R-0487.
Refer to proper Torque Chart in Maintenance Section of this manual.